[1]余 浩,刘红梅,田俊杰,等.基于 EDEM 的输送带动态跑偏仿真分析[J].机械与电子,2022,(08):8-13.
　YU Hao,LIU Hongmei,TIAN Junjie,et al.Simulation Analysis of Dynamic Deviation of Conveyor Belt Based on EDEM[J].Machinery & Electronics,2022,(08):8-13.
点击复制

基于 EDEM 的输送带动态跑偏仿真分析()
分享到：

《机械与电子》[ISSN:1001-2257/CN:52-1052/TH]

卷:
期数:
2022年08期
页码:
8-13
栏目:
设计与研究
出版日期:
2022-08-24

文章信息/Info

Title:
Simulation Analysis of Dynamic Deviation of Conveyor Belt Based on EDEM
文章编号:
1001-2257 ( 2022 ) 08-0008-06
作者:
余 浩 1 ; 刘红梅 1 ; 2; 田俊杰 1 ; 张 健 1 ; 艾闻博 1 ; 姚 庆 1
1. 南通大学机械工程学院,江苏 南通 226019 ; 2. 南通大学交通与土木工程学院,江苏 南通 226019
Author(s):
YU Hao1 ;  LIU Hongmei1 ;  2 ;  TIAN Junjie1 ;  ZHANG Jian1;  AI Wenbo1 ;  YAO Qing1
( 1.School of Mechanical Engineering , Nantong University , Nantong 226019 , China ; 2.School of Transportation and Civil Engineering , Nantong University , Nantong 226019 , China )
关键词:
离散元法; 单因素控制变量法; 物料颗粒速度; 输送带跑偏
Keywords:
discrete element method ;  single factor control variable method ;  material particle velocity ;  deviation of conveyor belt
分类号:
TD528 ; TH222
文献标志码:
A
摘要:
针对带式输送机在运输物料过程中由于落料不均易出现输送带跑偏的问题,通过离散元法进行分析。运用单因素控制变量法进行 EDEM 仿真计算,分析了不同落料高度、不同落料速度及不同湿度状态下对物料流在导料槽出料口处速度与输送带跑偏的影响。通过对比与研究发现,物料落料高度、落料速度及物料颗粒湿度对带式输送机转运系统会产生影响,在此情况下单一改变某一参数会降低输送带跑偏趋势。研究发现,在一定条件下输送带跑偏趋势随落料高度增加而增加,也随落料速度增加而增加,但是与物料湿度成相反趋势,即物料湿度增大,输送带跑偏趋势减小。同时需注意物料湿度增加,物料附着导料槽影响下段输送带受料。
Abstract:
Aiming at the problem that the belt conveyor is prone to deviation due to uneven blanking in the process of transporting materials , the discrete element method is used to analyze it.In this paper , the single factor control variable method is used for edem simulation calculation.The effects of different blanking height , blanking speed and humidity on the speed of material flow at the outlet of the guide chute and the deviation of the conveyor belt are analyzed.Through comparison and research , it is found that the material blanking height , blanking speed and material particle humidity would have an impact on the transfer system of belt conveyor.In this case , changing a single parameter would reduce the deviation trend of the conveyor belt.The study finds that : under certain conditions , the deviation trend of the conveyor belt increases with the increase of the blanking height , and also increases with the increase of the blanking speed. However , the deviation trend of the conveyor belt is opposite to the humidity of the material.The greater the material humidity , the smaller the deviation trend of the conveyor belt .At the same time , it should be noted that with the increase of material humidity the material is easy to attach to the material guide chute , affecting the material receiving of the lower conveyor belt.

参考文献/References:

[ 1 ] 孙东阁 . 管状带式输送机在散料输送中的应用分析[ J ] . 科技创新导报, 2019 , 16 ( 28 ): 206 , 208.

[ 2 ] 左金荣,张铜钢,朱满平 . 调整皮带机胶带跑偏的方法[ J ] . 江西煤炭科技, 2006 ( 2 ): 52-53.
[ 3 ] 蔡柳 . 煤散料在刮板输送机中部槽内的运输状态与力学行为[ D ] . 太原:太原理工大学,2016.
[ 4 ] 宋伟刚,王天夫 . 散状物料转载系统设计 DEM 仿真方法的研究 [ J ] . 工程设计学报,2011 , 18 ( 6 ): 428-436 , 456.
[ 5 ] 周文君,卫红波 . 基于 EDEM 的带式输送机输送过程仿真及分析[ J ] . 煤矿机械, 2013 , 34 ( 5 ): 89-91.
[ 6 ] 孟宪振 . 基于 EDEM 的带式输送机转接溜槽结构优化[ J ] . 起重运输机械, 2016 ( 7 ): 98-101.
[ 7 ] 夏鹏,李郁,杨公波 . 散粒物料堆积角离散元仿真研究[ J ] . 起重运输机械, 2015 ( 2 ): 107-110.
[ 8 ] TSUNAZAWA Y , FUJIHASHI D , FUKUI S , et al. Contact force model including the liquid-bridge force for wet-particle simulation using the discrete element method [ J ] .Advanced powder technology , 2016 , 27( 2 ): 652-660.
[ 9 ] 姜世平,于海龙,芮筱亭,等 . 散体系统冲击破碎的动力学分析[ J ] . 爆炸与冲击, 2014 , 34 ( 2 ): 247-251.
[ 10 ] HOOMANS B , KUIPERS J , BRIELS W J , et al.Discrete particle simulation of bubble and slug formation in a two-dimensional gas-fluidised bed : a hard sphere approach [ J ] .Chemical engineering science , 1996 , 51 ( 1 ): 99-118.
[ 11 ] CUNDALL P A , STRACK O. A discrete numerical model for granular assemblies [ J ] .Géotechnique , 2008 , 30 ( 3 ): 331-336.
[ 12 ] CROWE C T , SOMMERFIELD M , TSUJI Y.Multiphase flows with droplets and particles [ M ] .Boca Raton : CRC Press , 2011.
[ 13 ] GUI N , YANG X T , TU J Y , et al.An extension of hard-particle model for three-dimensional non spherical particles : Mathematical formulation and validation [ J ] .Applied mathematical modelling , 2016 , 40( 4 ): 2485-2499.
[ 14 ] GUI N , YANG X T , JIANG S Y , et al.A soft-sphere imbedded pseudo-hard-particle model for simulation of discharge flow of brick particles [ J ] .AIChE Journal , 2016 , 62 ( 10 ): 3562-3574.
[ 15 ] 刘羽平,张拓,刘妤 . 稻谷颗粒模型离散元接触参数标定与试验 [ J ] . 中国农业科技导报,2019 , 21 ( 11 ):70-76.

备注/Memo

备注/Memo:
收稿日期: 2022-03-08
基金项目:江苏研究生科研与实践创新计划项目( KYCX20 _ 2823 );;江苏高校优势学科建设工程三期项目(苏政办发[ 2018 ] 87 号);南通大学博士启动基金项目( 2018-33 )
作者简介:余 浩 ( 1994- ),男,江苏盐城人,硕士研究生,研究方向为林业、农业、建筑等材料生产设备及工艺;刘红梅 ( 1968- ),女,江苏海安人,博士,教授,研究方向为建筑固废再生利用与绿色建材、建筑节能技术与管理、建筑材料生产设备及工艺等;田俊杰 ( 1997- ),男,江苏常熟人,硕士研究生,研究方向为林业、农业、建筑等材料生产设备及工艺;张 健 ( 1995- ),男,江苏邳州人,硕士研究生,研究方向为林业、农业、建筑等材料生产设备及工艺;艾闻博 ( 1994- ),男,江苏南通人,硕士研究生,研究方向为林业、农业、建筑等材料生产设备及工艺;姚 庆 ( 1986- ),男,江苏南通人,博士,讲师,研究方向为机械制造加工、新能源新材料及装备,通信作者。
更新日期/Last Update: 2022-08-26